Pneumatic Pistol Range Target Systems

Multi-Purpose Pneumatic Target System

#PP-MPPTS

A multi-target modular target system that can be ground anchored, free standing or mobile mounted. This system offers the user pneumatic turning targets, resettable head plate targets, removable steel chest plates, swing up targets, static steel and reactive targets, and one or two electronic moving target arrays that move the span of the range both directions. The target mechanisms are protected by an angled AR500 Steel Wall steel deflector plate to negate the need for a permanent protective front berm. The AR500 Steel Wall is angled downwards at 20 degrees, to deflect ricochets to the ground. Optional ballistic rubber is available as well for this wall. A ruggedized RF/hardwire Master Range Control System configured per user definition controls the system operation.

View GSA Listing

Autonomous Pneumatic Target System with 90° actuation

#PP-PTS90

A 90° actuated turning target array system that can be stand or wall mounted and holds a standard military 20”x40” E-target silhouette without modification. Each target is individually controllable or can act as synchronized. Full ballistic protection with AR500 deflector plates. All hardware, wiring and associated equipment fully ballistic protected as well. Controllable by hard-wire cable, Ethernet or Radio Frequency (RF) receiver.

View GSA Listing

Autonomous Pneumatic Target System with 180° actuation

#PP-PTS80

A 180° actuated friend/foe turning target array system that can be stand or wall mounted and holds a standard military 20”x40” E-target silhouette without modification. Each target is individually controllable or can act as synchronized. Full ballistic protection with AR500 deflector plates. All hardware, wiring and associated equipment fully ballistic protected as well. Controllable by hard-wire cable, Ethernet or Radio Frequency (RF) receiver.

View GSA Listing

Pneumatic Range Control System

#PP-PTSRCS

Master Range Control System for Pneumatic Range

The Patriot Pistol Pneumatic Target Control System provides RF, Ethernet or hardwired full control of the pneumatic pistol range. Includes a ruggedized laptop computer and ruggedized handheld controller. Allows automated or manual control with selectable pre-programmed scenarios, pre-programmed test cycles, and programmable ability.

View GSA Listing

Pneumatic Target System Compressor with Dryer & Filter System

#PP-GX575

Pneumatic compressor package includes compressor, air dryer and after cooler with auto drain and filters. Typical is a 7.5-HP 53-Gallon Rotary Screw Air Compressor (208-230/460V 3-Phase) but the system will be sized per site and number targets.

View GSA Listing